.svg?v=144615871337664008991726520056)
Protect this vulnerable area of your car from damage with a full rocker panel of impact-resistant PPF.
Most customers install this kit themselves. Some experience with PPF installation is helpful, but not necessary.
Installation time: 1 hour
Recommended Temperature: 65°F – 75°F
Tools needed:Simply add water to provided installation bottles.
How to Video:
Unfortunately, PPF will not adhere to ceramic coating. We do not recommend installing if you already have a ceramic coat.
We highly recommend waiting at least 24 hours before driving. This ensures your PPF has had time to adhere fully so water and debris can’t get under the surface.
PPF is best installed in temperatures between 65 and 75 degrees F. If it’s too cold, it may feel stiffer. If it’s too hot, it’ll stretch more.
If it’s a small finger, the easiest way to push it down is to use your tack solution and then push it down with your squeegee. If it persists, wrap your squeegee with microfiber and squeegee it down. The microfiber will absorb the water, making it tackier.
If it is larger than a nickel, you want to lift the PPF and squeegee it down again. If it’s smaller than a nickel, it should dissipate and evaporate within time.
We recommend waiting at least 24 hours but 48 hours to be safe.
Yes, everything you need is provided in the kits. All you’ll need to add is water to the slip and tack bottles.
No, our kits come pre-cut to make installation easier for you!
You can, but please be extremely careful. You want to be careful around all the edges. If you directly point the spray gun near the edge, it may remove the film. Don’t directly spray on the edges, and you’ll be fine.
PPF is easier to adjust since it is a wet install compared to vinyl which is a dry install. If you do make a mistake, reach out to us, and we can send you a replacement at cost.
Our film is rated for 10 years.
Absolutely. There are many ceramic coatings that are specifically for PPF which will make the car even easier to keep clean!
Good quality film that includes all the equipment for a successful installation. Highly recommended.
The coverage on this pre-cut PPF kit is very good. I only had minimal stretching needed to fit within all margins, but having a good dilution ratio for slip solution is a MUST. Highly recommend this DIY in an area with lots of space to bend down a lot.
With the videos provided, it was an easy install! I would prefer a pdf of instructions but the videos were decent enough albiet a bit time consuming.
However, the product itself holds up well, I have driven in heavy snow /salt conditions and it really does prevent any kickup on rocks/salt. I would highly recommend only doing Touchless car washes though as I took it through a regular car wash and it peeled off - though the customer service was great and sent me replacement parts!
Installation was easy and I can tell they will make a difference in the long run to protect my car
I just installed today in my garage. As expected, the second side was easier after doing the first. I’m looking forward to seeing how it holds up. Watch the video provided by Tesbros prior to install. Everything is explained well!
