.svg?v=144615871337664008991726520056)
This kit comes with everything to protect this high-impact area from avoidable damage.
Most customers install this kit themselves. Some experience with PPF installation is helpful, but not necessary
Installation time: 30 minutes
Recommended Temperature: 65°F – 75°F
Tools needed: Simply add water to provided installation bottles.
How to Video:
PPF is best installed in a temperature range between 65 and 75 degrees F. If it’s too cold, it may feel stiffer. If it’s too hot, it’ll stretch more.
If it’s a small finger, the easiest way to push it down is to use your tack solution and then push it down with your squeegee. If it still persists, wrap your squeegee with microfiber and squeegee it down. The microfiber will absorb the water, making it tackier.
If it is larger than a nickel, you want to lift the PPF and squeegee it down again. If it’s smaller than a nickel, it should dissipate and evaporate within time.
Yes, everything you need is provided in the kits. All you’ll need to add is water to the slip and tack bottles.
No, our kits come pre-cut to make installation easier for you!
PPF is easier to adjust since it is a wet install compared to vinyl which is a dry install. If you do make a mistake, reach out to us, and we can send you a replacement at cost.
Our film is rated for 10 years.
Placed this on my new Model 3 before getting any scratches. Great way to add protection for a first time PPF application. Now I’m ready to tackle the door sill and trunk PPF.
Like everything else from Tesbros, this was also easy to install. It was precut and clearly labeled for driver or passenger so very easy to put on. I bought this because I saw how my nephew and niece were climbing in and out of the car. Wanted to protect the soft paint from scratches.
I watched the video to help me install. Take your time on this one. Spray the "tack" bottle which is just water to displace the slip solution to help the PPF stick better. Work form the inside to the outside. Parking it in the sun will help it dry.
Install went well, except the instructions should state to not close your door for 24 hours after install. I waited a few hours, closed the door only to find that the rubber seal of the door had stretched the PPF and caused slight overhang which I imagine would cause the piece to lift eventually. I removed the pieces and re-ordered. Second instance came out perfect once the PPF had been given adequate time to adhere.
Easy to install. Another great product made by tesbros.
