Most customers install this kit themselves. Some experience with vinyl wrap installation is helpful, but not necessary
Installation time: 15 minutes
Recommended Temperature: 65°F – 75°F
How to Video:
This PPF protects your light from rocks and debris that will inevitably fly up while driving.
Most customers install this kit themselves. Some experience with vinyl wrap installation is helpful, but not necessary
Installation time: 15 minutes
Recommended Temperature: 65°F – 75°F
How to Video:
Unfortunately, PPF will not adhere to ceramic coating. We do not recommend installing if you already have a ceramic coat.
We highly recommend waiting at least 24 hours before driving. This ensures your PPF has had time to adhere fully so water and debris can’t get under the surface.
PPF is best installed in temperatures between 65 and 75 degrees F. If it’s too cold, it may feel stiffer. If it’s too hot, it’ll stretch more.
If it’s a small finger, the easiest way to push it down is to use your tack solution and then push it down with your squeegee. If it persists, wrap your squeegee with microfiber and squeegee it down. The microfiber will absorb the water, making it tackier.
If it is larger than a nickel, you want to lift the PPF and squeegee it down again. If it’s smaller than a nickel, it should dissipate and evaporate within time.
We recommend waiting at least 24 hours but 48 hours to be safe.
Yes, everything you need is provided in the kits. All you’ll need to add is water to the slip and tack bottles.
No, our kits come pre-cut to make installation easier for you!
You can, but please be extremely careful. You want to be careful around all the edges. If you directly point the spray gun near the edge, it may remove the film. Don’t directly spray on the edges, and you’ll be fine.
PPF is easier to adjust since it is a wet install compared to vinyl which is a dry install. If you do make a mistake, reach out to us, and we can send you a replacement at cost.
Our film is rated for 10 years.
Absolutely. There are many ceramic coatings that are specifically for PPF which will make the car even easier to keep clean!
I purchased this and have to my professional installer. He said the foundation series sticker was cut very poorly. I have him remove and throw the vinyl away.
Great products as usual! Easy install and looks great!
The long DRL part was a bit tough, it wouldn't center up and down easily. Due to this I had a small amount overhang below the light, and had to attempt to wrap it. I think if the piece was a bit wider, and allowed a proper wrap, it would be better. I'm now concerned about dust getting under it and peeling it away sooner than it should.
The cost is really too high as well, $50-$60 would be more reaonsable.
Very easy to use, thank you!