.svg?v=144615871337664008991726520056)
Il combine nos enveloppes Pillar Delete et Front Bumper Sport Mode, en plus, il est livré avec deux ensembles juste au cas où vous feriez une erreur !
La plupart des clients installent ce kit eux-mêmes. Une certaine expérience de l'installation d'une pellicule de vinyle est utile, mais pas nécessaire.
Temps d'installation : 1,5 heures
Température recommandée : 65°F – 75°F
Outils nécessaires : pistolet thermique / sèche-cheveux recommandé mais non obligatoire.
Comment faire une vidéo :
Suppression de pilier
Modèle sportif
No, not at all. The wrap kit allows you to apply a professionally looking wrap without disassembly.
Unless you REALLY overstretched it, you can get it back to normal stretch. Vinyl is memory-based so if you just heat it, it will revert back to its original state. Use a heat gun or hairdryer and keep your heat moving in the area. You’ll see it shrink back. If you don’t see that it is shrinking back, you may have added too much heat and will have to use your extra piece.
You can use a heat gun or a hairdryer but you want to use a heat gun whenever you need to stretch or conform around awkward areas. When using heat, don’t stay in one area. Keep your gun moving and roughly 6 inches away.
The kit comes with everything you need, except a heating source. We recommend using a heat gun or even a hairdryer if needed.
Our DIY kits are designed with beginners in mind. You do not need prior knowledge to install these kits, however, we do recommend studying our videos and familiarizing yourself with vinyl to get the most out of your kit!
It’s recommended to only hand wash your Tesla. Due to automatic carwashes being brushless, they tend to use heavy chemicals to break things down which can be harmful to the vinyl.
Top pillar wasn’t as easy to install as the video depicted but I was able to get it done with help of a heating gun. Looks great and was worth the time!
great customer service, install requires some DIY, they designed it well and easy to figure out. Only issue is i think the pillar delete should've been cut a 1-2cm wider and it would be easy to trim, but if you install too high or too low, its going to show.
Looks amazing on my model y
I had to pay a professional to do it because I tried and it didn’t look great. Tesbro customer service was awesome and they sent me another set without hesitation
I found the vinyl relatively easy to install after watching a few videos. It took me one attempt at the front bumper to get the hang of it so I'm glad they include two sets of vinyl with each order. After the first attempt things went smoothly. I would recommend using a heat gun rather than a hair dryer. You can get a cheap heat gun for $25.
All said and done it really adds appeal to the car and I would definitely purchase again.
