Thank you for submitting a review!
Your input is very much appreciated. Share it with your friends so they can enjoy it too!
The 'stickers' are a bit more sticky and less flexible than others I've worked but that's probably a good thing with the design. Using a heat gun makes it much easier to work with. I was frustrated with the instructions and the actual backing on them were in the wrong direction. So peeling the back and starting the sticker on the charging console was extremely difficult as the peel offs on the back were vertical vs horizontal as the instructions clearly had. Worked but that was hard and frustrating.
Middle console wrap was printed wrong direction so applying it was extremely difficult. Instead of pulling the cover for sticky adhesive horizontally they were printed vertically which means I had a lot of hard time applying to the top corners correctly. The top part above the phone charger was extremely difficult to apply as well and there is a small part that does not stick to the edges so when you slide the phone console up, it makes a paper rubbing noise. The cup holder area has poor adhesive as well so the edges near the silver part don’t stick.
Very satisfied overall. I would say it’s a 98% match. Very hard to tell that it isn’t stock. It doesn’t have the same texture as the dash obviously because it’s a sticker, but it looks very close. I’m super picky and I like it. It was kind of a pain in the *** to install it perfectly but they give you two sets in case you mess up....which I was very grateful for. Well worth the effort though!!! Make sure to buy a heat gun or a good blow dryer for this install.