.svg?v=144615871337664008991726520056)
Protect this vulnerable area of your car from damage with a full rocker panel of impact-resistant PPF.
Most customers install this kit themselves. Some experience with PPF installation is helpful, but not necessary.
Installation time: 1 hour
Recommended Temperature: 65°F – 75°F
Tools needed: Simply add water to provided installation bottles.
How to Video:
Unfortunately, PPF will not adhere to ceramic coating. We do not recommend installing if you already have a ceramic coat.
We highly recommend waiting at least 24 hours before driving. This ensures your PPF has had time to adhere fully so water and debris can’t get under the surface.
PPF is best installed in temperatures between 65 and 75 degrees F. If it’s too cold, it may feel stiffer. If it’s too hot, it’ll stretch more.
If it’s a small finger, the easiest way to push it down is to use your tack solution and then push it down with your squeegee. If it persists, wrap your squeegee with microfiber and squeegee it down. The microfiber will absorb the water, making it tackier.
If it is larger than a nickel, you want to lift the PPF and squeegee it down again. If it’s smaller than a nickel, it should dissipate and evaporate within time.
We recommend waiting at least 24 hours but 48 hours to be safe.
Yes, everything you need is provided in the kits. All you’ll need to add is water to the slip and tack bottles.
No, our kits come pre-cut to make installation easier for you!
You can, but please be extremely careful. You want to be careful around all the edges. If you directly point the spray gun near the edge, it may remove the film. Don’t directly spray on the edges, and you’ll be fine.
PPF is easier to adjust since it is a wet install compared to vinyl which is a dry install. If you do make a mistake, reach out to us, and we can send you a replacement at cost.
Our film is rated for 10 years.
Absolutely. There are many ceramic coatings that are specifically for PPF which will make the car even easier to keep clean!
I’ve been researching Tesbros and PPFs in general for years. When I finally bought my Tesla Model Y, the PPF on front is what I wanted but I can’t afford it at the moment. So I went with these rockers and it’s awesome. I love how the package came with two spray bottles for slip and tack which I used w distilled water and alcohol. Will look forward to the discounts for the front PPF and get that done too! Thanks Tesbros!
I was worried about the look of the doors after installing the protection. I was thinking it’ll be visible and doesn’t look nice. But after putting that on - which was easy as pie - I barely can see that. Apart form that it’s from high quality material and thick. I absolutely loved it and am thinking about getting PPF for front as well.
This was my first time installing any sort of PPF. But after watching the tutorial on YouTube the install went amazingly well.
It's very straightforward and the PPF is very forgiving. If you mess up or see bubbles or debris you can just peel it off and do it over again without losing the adhesion. Will be purchasing more product from Tesbros!
Easiest to intall
Bought these after I ordered just the quarter panel ppf from Tesla. The protection is much better as it covers the whole rocker and up into the rear quarter for not much more money. I was able to trim the pieces from Tesla and raise the protection area a couple inches seamed up to the rocker ppf.
If you are in area with gravel and road debris these are a must!
