This kit comes with everything you need to protect your taillights while also vented to allow normal condensation evaporation. It also won’t interfere with the touch to open on the charge port.
***NOTE: In august of 2020, Tesla changed the location of the weeping hole. We DO provide both variations in your kit. Please keep this in mind if the hole doesn’t line up.
Most customers install this kit themselves. Some experience with PPF installation is helpful, but not necessary.
Installation time: .5 hours
Recommended Temperature: 65°F – 75°F
Tools needed: Simply add water to provided installation bottles.
How to Video:
We highly recommend waiting at least 24 hours before driving. This ensures your PPF has had time to adhere fully so water and debris can’t get under the surface.
PPF is best installed in temperatures between 65 and 75 degrees F. If it’s too cold, it may feel stiffer. If it’s too hot, it’ll stretch more.
If it’s a small finger, the easiest way to push it down is to use your tack solution and then push it down with your squeegee. If it persists, wrap your squeegee with microfiber and squeegee it down. The microfiber will absorb the water, making it tackier.
If it is larger than a nickel, you want to lift the PPF and squeegee it down again. If it’s smaller than a nickel, it should dissipate and evaporate within time.
We recommend waiting at least 24 hours but 48 hours to be safe.
Yes, everything you need is provided in the kits. All you’ll need to add is water to the slip and tack bottles.
No, our kits come pre-cut to make installation easier for you!
You can, but please be extremely careful. You want to be careful around all the edges. If you directly point the spray gun near the edge, it may remove the film. Don’t directly spray on the edges, and you’ll be fine.
PPF is easier to adjust since it is a wet install compared to vinyl which is a dry install. If you do make a mistake, reach out to us, and we can send you a replacement at cost.
Our film is rated for 10 years.
Absolutely. There are many ceramic coatings that are specifically for PPF which will make the car even easier to keep clean!
United StatesAs a newbie to ppf this was definitely a level one easy install especially with the video documenting the process.
United StatesIt very easy and straightforward to install. Perfect fit.
CanadaPurchased this PPF set due to having my past Tesla not having protection on the tail lights. Now I don’t have to worry about using slightly dirty microfibre towels that may make some micro scratches on the plastic lens on my rear taillights. The ppf pieces were accurately measured. Just take your time lining up the seams of the middle lights and you’ll be fine! Watch the video once or twice before for good measure! Great product and highly recommend!
United StatesAs always, TESBROS delivers quality and service. I have been very happy with all the products I had bought from them!
United StatesThe PPF went on smooth, the instructions were easy and solution was premixed so just had to add water. The one flaw and it’s a pretty big one is that the weeping hole precut hole was incorrect on my 2022 model Y (inner taillight), I had to make my own hole with a knife during install, not a fun process. Otherwise and great kit.
Thanks for your feedback, Jeremy! We fixed this issue and if you'd like a replacement, we'd be happy to send you one!
CanadaFor my first attempt, it looked great and stuck to the lights without any issues. There is even a slip solution provided. Rubbing alcohol can be found at a pharmacy.
CanadaThank you for making this product! On many previous vehicles taillights would dull and get micro scratches after a few years of hand washes. This product prevents that, is replaceable and as a bonus also covers and protects the plastic charge port door, the only exterior shiny piece of black plastic which is very susceptible to micro scratches as well. Thanks!
